HomeHelpline: +44 (0)1823 666213

Getting surfaces Christmas-ready

Published 27 Nov 2019

AuthorJulie Lock

Getting surfaces Christmas-ready

We all want our homes to look their best, especially when guests come to visit. With Christmas fast-approaching, it’s a good time to give floors and tiles a once-over, to restore appearance and make any routine cleaning easier. broom-1837434_1920

Well-used floors and bathroom tiles are two areas that often need a thorough deep clean, to remove a build-up of organic dirt and stains that thrive in moisture.  Grout and silicone joints, and tiled shower areas can be particularly tricky to clean and tough cleaning products may seem like the best solution…. but take care. Many of the ‘best-selling’ products – and sometimes even those from eco ranges - contain acid which can damage tiles, grout, chrome fittings and any protective sealer that’s been applied.

 

GrimexTo deep clean safely, we recommend LTP Grimex.  As the name suggests, it removes grime and stains, including oil, grease, soot and wax.  It’s safe to use on natural stone, as well as porcelain and ceramics, and it comes in one litre and five litre cartons, as well as a trigger spray for more precise application.LTP Mouldex 500ml

 

For grout and silicone that’s stained with mould spores, we recommend LTP Mouldex.   This treatment comes in a pump spray and it's formulated to cling to surfaces, which targets the treatment and prevents run-off.   Mouldex has a bleaching action which helps restore colour and it’s antibacterial, so it helps prevent mould regrowth.  It can be used on natural as well as artificial stone – and on coloured grout – but it’s always best to test first, in an inconspicuous area.

How to use LTP Grimex

For areas that are slightly grubby – and for absorbent tiles – dilute one part of Grimex to ten parts of warm water.  Apply with a cloth or mop and rinse with clean water.

For dirtier surfaces, use a stronger 1-3 dilution and agitate the surface with a brush.  Let the solution act for 5-10 minutes, mopping with additional solution to keep the tiles wet, and agitate again before mopping up and rinsing thoroughly with clean water.

For built-up grime and stubborn stains, Grimex can be used neat and then thoroughly rinsed.

bath-2192_1920

Grimex Spray is really handy for wall tiles, work tops, grout lines and fireplace surrounds.  It’s sprayed directly onto the surface, once any dust has been removed, and left to act for a few minutes.  A little water can be applied and the surface can be agitated with a brush or mild abrasive pad if need be – and the treatment can be repeated if necessary.

If surfaces have been sealed, you’ll need to re-apply a sealant after cleaning and rinsing, and having allowed the surface to completely dry out; we recommend a minimum of 24 hours.  If you need advice on the best sealant to use, get in touch or see the range at https://www.ltp-online.co.uk/cat

How to use LTP Mouldex

Before applying the treatment, make sure that tiles are completely dry.  Spray Mouldex 5-10cm from the surface and leave it to act for 45 minutes.  Then, apply a little water and agitate with a stuff brush to help lift the grime and dirt. Finally, rinse the surface thoroughly with water and a clean sponge.  For silicone and elastic grouting, and for stubborn stains, the treatment can be left overnight.    NB.  Mouldex shouldn’t be used with acid-based residual grout removers or other acid- based cleaners.

For more advice, contact the LTP team on tel. 01823 666213 or email info@ltp-online.co.uk