Renovation
Dull or dirty floors can be cleaned using the following procedures:
1) Floors Sealed With Linseed Oil/Beeswax
a) Use LTP Solvex to remove the surface layer of wax and then wash with LTP Grimex.
b) Apply one coat of LTP Stone Oil, following instructions on the container.
c) Allow 24 hours for LTP Stone Oil to cure before finishing with LTP Beeswax.
2) Floors Sealed With LTP Ironwax Satin , LTP Ironwax Gloss
Or LTP Glaze Protector
a) Remove surface seal with LTP Grimex or LTP Power Stripper.
b) Rinse well with water and allow to dry thoroughly (24 hours).
c) Re-seal using LTP Ironwax Satin, LTP Ironwax Gloss or LTP Glaze Protector.
3) Floors Sealed With LTP Mattstone, LTP Colour Intensifier and Stainblock Or LTP MPG Sealer.
a) Wash floor thoroughly with LTP Grimex following the instructions on the container.
b) Rinse thoroughly with plenty of water and allow to dry for a minimum
of 24 hours.
c) Re-apply the LTP Mattstone, LTP Colour Intensifier & Stainblock or LTP MPG Sealer following instructions on the container.
Place a teaspoon of water on the intensively cleaned or untreated dry surface. Time how long it takes for the water to fully absorb.
- High Porosity - Water is absorbed within 5 minutes: 4 coats of sealer required in normal conditions.
- Medium Porosity - Water is absorbed within 15 minutes: 3 coats of sealer required in normal conditions.
- Low Porosity - Water is absorbed within 1 hour or longer: 2 coats of sealer required in normal conditions.
LTP Grout & Tile Protector" title="
LTP, Tone Estate, Milverton Road, Wellington, Somerset, TA21 0AN
T +44 (0)1823 666213
F +44 (0)1823 665685
E info@ltp-online.co.uk