Coverage Calculator

Calculate the amount you will require to clean, seal and maintain your surface. Enter the surface area in square metres (calculated by measuring one side in metres and another side at right-angles to the first side and multipling the two measurements) and the coverage calculator provides the amount required, in litres.

Porosity `Quick Test`

This test will help to establish whether the surface porosity of the tile is high,medium or low.
When the intensively cleaned or new /untreated surface is completely dry, place a teaspoon of water on a tile and time how long it takes for the water to absorb.

  • High Porosity - Water is absorbed within 5 minutes: 4 coats of sealer required in normal conditions.
  • Medium Porosity - Water is absorbed within 15 minutes: 3 coats of sealer required in normal conditions.
  • Low Porosity - Water is absorbed within 1 hour or longer: 2 coats of sealer required in normal conditions.

Once you have established the surface area, porosity and preferred products then use the table below to work out quantities required.

Enter tile area (in sq/metres)
ProductLevel of Contamination
Intensive CleanersHighMediumLow
LTP Grimex
LTP Grout Stain Remover
LTP Power Stripper
LTP Solvex
LTP Mouldex
ProductLevel of Porosity
Traditional SealersHigh
4 Coats Recommended
Medium
3 Coats Recommended
Low
2 Coats Recommended
LTP Stone Oil Antique
LTP Stone Oil
LTP Genuine Turpentine
LTP Boiled Linseed Oil
LTP Antique Beeswax
LTP Clear Beeswax
ProductLevel of Porosity
SealersHigh
4 Coats Recommended
Medium
3 Coats Recommended
Low
2 Coats Recommended
LTP Ironwax Primer
LTP Ironwax Gloss
LTP Ironwax Satin
LTP Mattstone
LTP Colour Intensifier and Stainblock
LTP MPG Sealer
LTP Grout & Tile Protector Aerosol (Tiles)
LTP Grout & Tile Protector Aerosol (Grout)
LTP Wall and Floor Grout Protector
LTP Wall and Floor Grout Protector Spray
LTP Glaze Protector
Maintenance Products
LTP Floorshine
LTP Waxwash
LTP Multiclean
LTP Stonewash
SHOPPING BASKET
BUY PRODUCT
POROSITY `QUICK TEST`

Place a teaspoon of water on the intensively cleaned or untreated dry surface. Time how long it takes for the water to fully absorb.

  • High Porosity - Water is absorbed within 5 minutes: 4 coats of sealer required in normal conditions.
  • Medium Porosity - Water is absorbed within 15 minutes: 3 coats of sealer required in normal conditions.
  • Low Porosity - Water is absorbed within 1 hour or longer: 2 coats of sealer required in normal conditions.
PROMOTION
<a href=LTP Grout & Tile Protector" title="LTP Grout & Tile Protector"/>

LTP Grout & Tile Protector

(600ml Aerosol)

Was £17.19

Now £13.75

LTP, Tone Estate, Milverton Road, Wellington, Somerset, TA21 0AN
T +44 (0)1823 666213
F +44 (0)1823 665685
E info@ltp-online.co.uk